Hook up high level input amp

hook up high level input amp

How to wire high-level input on an amplifier?

Here are the popular choices to wire high-level input on an amplifier. 1. Use a Line Output Converter A line output converter or an LOC has a high-voltage resistor and a transformer. It connects to the amplifier using an RCA patch cable. You need to ground the transformer of the device with LOC cables meant for this purpose.

What are high level inputs on a radio?

High level inputs means that you are using the speaker wire leads off of the back of the radio instead of using the RCA connections. You can take the speaker wire connections and use them to send the input signal to the amplifier.

How to hook up a subwoofer to an amp?

For every speaker or subwoofer you want to connect with amp, strip back the color-coded right and left speaker wires, and then connect the wire leading to your amplifier. 3. Hook-Up Amp Using Line Output Converter (LOC) A line output converter speaker level signals to RCA signals that are used by an amplifier.

How to hook up an amp to a car?

In these inputs, the voltage is higher than a standard RCA input so called the “High-Level Input”. These inputs give you clear and amazing sound quality. To hook up your amp with this method, run “Red Power Wire” from your amplifier through vehicle’s firewall, routing to the battery connect with the fuse holder.

What is a high level input on an amp?

Amp manufacturers started using high level inputs to allows for easier integration into newer vehicles where so much of their data is controlled from the factory radio. You can use high to low converters for the amps to accept high level inputs directly. The best way of doing that is by using a Line Output Converter.

What is a speaker level input on a radio?

Speaker level inputs are used when you want to connect an amplifier to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs. It allows you to use the signal coming from the speaker outputs as an input source for the amplifier.

How do I connect a radio amplifier to a radio?

It allows you to use the signal coming from the speaker outputs as an input source for the amplifier. Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the amplifier with the source unit. Most aftermarket radios have multiple pairs of RCA outputs that can connect to multiple amplifiers.

How do you hook up a speaker to an amp?

Then connect the end going to the speakers to the wire coming from the amp’s output. Our 9-wire speaker cable will make it easier to run the connections. You will need two of these cables; one for the amp’s output and one for its input.

How do you hook up an amplifier to a car?

Prep the power and ground wires The amplifier installation kit comes with all the wires you need. When you open the kit, there is the power wire (red) in there. Pull out the wire, connect it to the positive battery terminal through your vehicle’s cabin, and extend it to where the amp is positioned or mounted.

Can you put a car AMP in the trunk of a car?

If you intend to install your amp in the trunk of your car, it’s a relatively short path to the rear deck speakers or a subwoofer, so reaching the amp shouldn’t be a problem. Driving front seat speakers will require you to run wiring under a door jamb or the floor carpeting to reach the speakers, however.

How to mount an amp to a car seat?

Choose a place that has flat floors, such as your trunk, in the passenger seat footwell, or under the rear seats. Check underneath your vehicle to make sure there aren’t any wires or pipes on the other side of where you want the amp. Hold the amp still as you mark the locations of the mounting holes in the corners with a marker or pencil.

How do I connect my amp to my speakers?

Connect the power cable into the port on your amp, and install a terminal on the other end. Finally, connect the terminal to your battery and link up your speakers to the amp. Turn the battery on to test your amp. For a step-by-step guide on how to wire your amp, keep reading!

Related posts: